![]() When load balancing calculation is performed for an Eth-Trunk, the interface rate cannot be used as a weight. In V200R011C10 and later versions, after the mixed-rate link enable command is run, interfaces with different rates can be added to the same Eth-Trunk. For example, GE electrical interfaces and GE optical interfaces can be added to the same Eth-Trunk. In versions earlier than V200R011C10, only interfaces with the same rate can join an Eth-Trunk.Devices at both ends of an Eth-Trunk must use the same link aggregation mode.Devices at both ends of the Eth-Trunk must use the same number of physical interfaces, duplex mode, and flow control mode.Check whether the interface configurations on both ends of an Eth-Trunk are consistent.Interface PHY Protocol InUti OutUti inErrors outErrorsĪfter the cables are successfully connected, the interface status changes from Down to Up. ![]() InUti/OutUti: input utility/output utility Check whether the interfaces between the two switches are connected through cables and are running properly.īefore connecting cables, run the display interface brief command to check interface status.Before configuring an Eth-Trunk, perform step 1 and step 2. ![]() Link aggregation can work in manual mode or LACP mode.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |